|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual provided the necessary information to properly use the C-3 deck. The manual was an excellent reproduction and very clear.
;
Product was very good. Received quickly and complete
;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Inbetriebnahme
Wahl der Regenerierstufe
Achtung! Die Wasserenthärtungsanlage im Gerät ist ab Werk auf Regenerierstufe L4 (Wasserhärte 18 - 22 °dH) eingestellt. Ist die örtliche Wasserhärte grö�er als 22°dH oder kleiner als 18°dH, mu� die Einstellung geändert werden. Dies kann jedoch nicht während eines Programmablaufes erfolgen. Folgende Handgriffe sind erforderlich: 1. Programmwahlschalter auf "STOP" stellen. Gerät, durch Drücken der Ein/Aus-Taste, einschalten. 2. Die Programmtasten "Startzeitvorwahl" und "Start" gleichzeitig ca. 5 Sekunden drücken, bis "L4" im Multidisplay angezeigt wird (werkseitige Einstellung). Taste so oft drücken, bis die gewünschte Stufe erscheint. Beispiel: Die örtliche Wasserhärte beträgt 40 - 45°dH. Einstellung It. Tabelle "L 8".
StartzeitVorwahl
PRIV01
Start
4. Wenn die Startzeitvorwahl-Taste nicht mehr gedrückt wird, geht der Geschirrspüler nach ca. 5 Sekunden automatisch wieder in seine Ausgangsstellung zurück. Die eingestellte Regenerierstufe ist nun gespeichert. Ein Spülprogramm kann gewählt werden.
StartzeitVorwahl
PRIV02
Start
Hinweis Liegt die Wasserhärte in Ihrem Wohngebiet unter 4°dH, so brauchen Sie kein Spezialsalz einfüllen. Wählen Sie die Regenerierstufe "L0", so bleibt die Signallampe "Salz" abgeschaltet.
3. Mit der Taste "Sartzeit-Vorwahl" kann nun die Regenerierstufe, die der örtlichen Wasserhärte entspricht, eingestellt werden (siehe Tabelle Seite 15).
INB05
16
|
|
|
> |
|